OV-7670 Camera Module

රු475.00

OV-7670 Camera Module

Add to Wishlist
Add to Wishlist
SKU: 139 Categories: ,
  • Photosensitive Array: 640×480
  • IO Voltage: 2.5V to 3.0V
  • Operating Power: 60mW/15fpsVGAYUV
  • Sleeping Mode: <20?A
  • Operating Temperature: -30 to 70 °C
  • Output Format: YUV/YCbCr4:2:2 RGB565/555/444 GRB4:2:2 Raw RGB Data (8 digit)
  • Lens Size: 1/6″
  • Vision Angle: 25 degree
  • Frame Rate: 30fps VGA
  • Sensitivity: 1.3V / (Lux-sec)
  • Signal to Noise Ratio: 46 dB
  • Dynamic Range: 52 dB
  • Browse Mode: By row
  • Electronic Exposure: 1 to 510 rows
  • Pixel Coverage: 3.6?m x 3.6?m
  • Duck Current: 12 mV/s at 60°
  • PCB Size (L x W): Approx. 1.4 x 1.4 inch / 3.5 x 3.5 cm

Pin Definition:

  • 3V3—–Input power supply voltage (3.3,5V is recommended, but not recommended)
  • GDN—–grounding point
  • SIO_C—SCCB interface control clock (Note: some low-level microcontrollers need pull-up control, similar to I2C interface)
  • SIO_D—SCCB interface serial data input (output) end (Note: some low-level microcontrollers need pull-up control, similar to I2C interface)
  • VSYNC—frame sync signal (output signal)
  • HREF—-line sync signal (output signal, generally not applicable, special case)
  • D0-D7—data port (output signal)
  • RESTE—Reset port (normal use pull high)
  • PWDN—-Power consumption selection mode (normal use pull low)
  • STROBE—Photo flash control port (not required for normal use)
  • FIFO_RCK—FIFO memory read clock control terminal
  • FIFO_WR_CTR—-FIFO write control terminal (1 is to allow CMOS to write to FIFO, 0 is forbidden)
  • FIFO_OE—-FIFO shutdown control
  • FIFO_WRST—FIFO write pointer reset terminal
  • FIFO_RRST—FIFO read pointer reset terminal